I'm suspecting a problem with the rain sensor - a Hunter Rain Click. Nothing on the display panel indicating a problem. All zones work fine in manual mode and in test mode. Each ONT serial number is recorded specifically to the property where it’s installed and it won’t work if it’s plugged in at a different property. Yesterday, I opened the controller box (Rainbird ESP 4MI) to see what time it was and I found the alarm led on. Only the CP router that plugs into the ONT should be taken when you move. If you're leaving a property where Ultrafast Full Fibre broadband is already installed please make sure that the Openreach Optical Network Terminator box is not removed as it's a home fixture/fitting. It’s better to call on a mobile if you can (or have it handy when you ring), in case they need to run tests on your phone line. If those checks haven’t fixed things, you’ll need to contact the company you buy your broadband from. If it works, then it's an issue with your router, not the connection. To view a detailed light status readout, select your device: Nokia G-010G-Q. If you've got another broadband router, try connecting that. Check all the cables are connected properly and haven’t come loose. If you’re using wi-fi, try a couple of devices to make sure it’s a problem with the connection and not the device itself. Make sure you give it enough time to power up before you try to connect to it again. Turn your broadband equipment off and then on again. Check any equipment that’s connected to your phone line is working too – things like routers, TVs, set-top boxes, modems, faxes, alarms and auto diallers (for care systems). Make sure your landline is working properlyĬheck your landline phone or handset isn’t faulty – unplug then reconnect any phones you have, then check each one has a dial tone. This means you’ll need to contact the company you buy your broadband from as there may be a problem with their network. If the “passive optical network” (PON) light is solid green and the “loss of service” (LOS) light is off, then it’s working properly. But any other equipment might not work.Ĭheck the lights on your Openreach equipment If there’s been a power cut, your equipment may still work if it has a back-up power supply – so you’ll be able to make an emergency call for a short period of time. Questions 6 1 0 0 ATTCares Administrator 105.4K Messages 3 y ago Hi TylerCox86, We will be happy to help. Have already reset everything such as modem, router, and wireless router. If the LED is off and then on again, it indicates that the system is reset successfully.Check you haven’t accidentally unplugged or switched off your equipment (for example a phone handset or router). Att fiber modem is showing red ALARM light and yellow/orange data light. Press the button to reset the device press and hold the button (longer than 10s) to restore the device to the default settings and reset the device. Press the RESET button by using a sharp-ended object and then release the button.That the ringing current voltage of the phone does not exceed 60 V AC otherwise, change another phone. The ONT provides a maximum ringing current voltage of 60 V AC.The phone does not ring when it receives a call, but the communication is normal when the phone is in the off hook state.⁌heck whether the connection of the USB device is correct. Check whether the WLAN service is started.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |